Barn Beam Mantel How To Install A Heavy Wood Mantel

Build a template using an old board.

Barn beam mantel how to install a heavy wood mantel.

Place a level on the mantel and adjust the mantel so it sits straight. The first is with screws and cantilevered bricks. Simply screw the bracket into wall studs or with a brick surface use lag bolts. This could also be done using only b.

Ask a friend to trace along the top of the mantel then set the mantel aside. Push the wooden mantel carefully into place using wood glue for extra support. Mark the area where the mantel will be and drill a pilot hole in each stud in the center of your 6 space. Bolts should be long enough to cover 2 3 of mantel depth the thickness of the backer board.

Screw lag bolts through the backer board and into the back of the mantel. Remove the old mantel. Locate the studs and mark. Caulk the seam and allow time to dry before using.

Remember to take into consideration your measurements so you know where to mark your holes top to bottom and side to side draw holes onto your mantel then using a wood spade bit slightly larger than your rods drill your holes. Drill pilot holes into the template board not attached to the wall at this point at the locations of the studs. Screw in your lag screws about 3 1 2. Hold the mantel above the fireplace at the height you wish to mount it at least 6 inches away from the firebox.

Using your template place the 2 4 onto the mantel and level it with a long level. In this video i show two different ways to install a barn beam mantel. The vail mantel model comes with a square mounting bracket not angled. Complete the fireplace installation masonry and enjoy.

Measure carefully and drill corresponding holes for the wood mantel. Make corresponding marks in the back of the mantel. Cut the board to the width of your fireplace. The board must be at least 3 4 of the height of your beam.

How to install a barn beam mantel.